My son bought this kart second hand with his own money and we have been slowly working our way through a series of bugs. We had to replace the head due to a...
Hello, I'm new to the group and you may have already recieved an email on this since i goofed my first post. I have a probelm with RPMS dropping off once you...
I had a similar problem and crimping the connectors at the coil did not improve performance because one of the connectors was cracked in half where the flat...
I would think too much fuel, not enough fire at WOT. I would look at both. Could be a weak connection or rectifier or a carb prob. Put a high performance...
Thanks Bob, I'll take a look at it. - Buzz ... From: Robert Batchelor To: yerfdoggx150@yahoogroups.com Sent: Tuesday, August 15, 2006 10:39 PM Subject: RE:...
Thanks Jim, I noticed also that the hose from the air filter is loose due to a broken support bracket. That implies too much air and not enough fuel to me. I...
Tomberlin Prodcut Group can supply all engine parts for the Yerf-Dog Howhit engine, their toll free number is 877-855-0196 and their website is tpg-info.net. ...
I haven't started the dawg in about a year (moving, family committments, etc.). The battery is charged and working fine. Before I stored it, I changed the...
hi I did the same thing only didn't do all the good stuff you did before letting it sit for a year, my problem was the electronic chokewhat i did was took...
I'll have to try the e-choke solution and the spray. The service manual doesn't do a great job of showing the wire colors/locations. The one I have is a first...
After sitting awhile the pilot jet typically gets plugged with gum. The pilot jet is your idle jet and its orifice is verrrry small. Sometimes you can get the...
Hi guys, This is a follow-up from some help I asked for here a couple weeks ago with my first post. I recieved good ideas back, but I'm still stuck.. Well it...
I'll give it a try. - Thanks ... From: guy48065 To: yerfdoggx150@yahoogroups.com Sent: Thursday, August 24, 2006 8:40 AM Subject: [yerfdoggx150] Re: High Speed...
I have adjusted them very recently. I know I got it right, I did it at least three times... :) ... From: braveskckass To: yerfdoggx150@yahoogroups.com Sent:...
Cain, I will probably make another run at those valves this weekend. If they are out of spec, which way do you think I need to go on the adjustment? Greater or...
If you're problem is that repeatable, it may be easier to diagnose: Use a can of starter fluid, with a short spray into the carb every 3 or 4 seconds, to keep...
I recently purchased the Yerf-dog 3206. I know that it sat untouched for at least a year. The fuel system was completely empty except for fuel in the...
Holding accelerator pedal (I'll assume that's what you're talking about) all the way open while attempting to start would be counterproductive. I'd guess that...
I wish that it was that simple. If I do not hold the accelerator all the way down the cart will not start. Once it is running it does idle for about five min....
Thanks. I called a local shop today and they suggested I order a new coil. I went along with that because I have been in he fuel system several times and all...
Normally the engine will never start with the pedal held down. This carb isn't like what's on an old car where you need to pump it a few times and hold it...
I have 2 karts 4 sale, the first one is a 2004 Yerfdog Gx 150 4209 in exellent condition with many upgrades for $800.00 and the other one is a 2005 Twister...
As an update on this problem, I recieved and installed the new coil last night. This, together with raising the idle (per a suggestion I got here)seems to have...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
