Well, both spindlews have now been reattached by welding. Finally got time to fix my passenger side snapped spindle (rear axle). Put the Dawg to work towing my...
--Thats a good one David. Have to mow one more time here in the North East. My 3yr.old M.T.D. mower has been the worse piece of crap to keep in service. What a...
I am having trouble getting my sons kart to start. Its been sitting for awhile. I have already changed the gas and fuel filter. The engine is getting spark but...
--Dont give it gas till it warms up. Clean out carb. Check for stuck Carb. parts; choke ,float etc. Good luck. Jim - In yerfdoggx150@yahoogroups.com,...
has any one seen or heard of the Hammerhead 250cc I head it was out and is the Mother of all go karts!!!!! Keith D. Ress [Non-text portions of this message...
I heard that it is geared very high and has pitiful low end. -Travis ... From: yerfdoggx150@yahoogroups.com [mailto:yerfdoggx150@yahoogroups.com]On Behalf Of...
Do a search on www.buggynews.com Raptoraz posted some pictures from east side motorsports a while back. It's a goreous looking buggy but we did hear it...
I seen one at Eastside the other day. I was told it has the same performance as my 150cc hammerhead But quicker pick up and will get to 40mph faster and the...
I HAD THE FOUR FRONT BUSHINGS REPLACED AND THE LEFT AND RIGHT SPINDLE. THE PROBLEM IS THAT ONE TIRE FACES INWARD AND THE OTHER TIRE FACES FORWARD. IS THERE...
If that's the case, then things have been changed in a big way. Previously it was geared for high speed and members of Buggynews drove the demo. We were a...
I am having problems with my son's 3206. At times the starter stays engaged. I've tried tracing the wiring but can't find a short or tear... When it is doing...
... I had the starter button go out on my daughters 3206.This is a total guess, but maybe your button is sticking and not releasing fully which keeps an...
... <gatorboy001@y...> ... stays engaged. I've tried tracing the wiring but can't find a short or tear... When it is doing this the only way to stop it is to...
Your starter solenoid could be bad. It's located in the electrical box. Disconnect the wires going to it. Then use your meter to see if you get 0 ohms...
Has anybody successfully trouble shooted this problem? I ran thru all the wiring checks in the service manual and all values were within spec. I do get spark...
Anytime you have an electrical problem like this it usually stems from a ground, corrosion, or eletrical part malfunction. Check all the connections. Grease...
Thanks Jim, Followed your advice and started troubleshooting from the kill switch back. I found a issue with the kill switch (Shorted out) I was able to get...
Sounds alot like a ground problem concerning that switch or wiring somewhere in the circuit. Also check your brake safety kill switch to make sure that it is...
-Yes, kill the kill switch! Kill it dead!- ... somewhere in the circuit. Also check your brake safety kill switch to make sure that it is not the one killing...
If you need parts or want to stock up on a couple things you might want ,you need to hurry. I called for parts again today, second time in two weeks. Bought 2...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
