It's questionable at the moment, my son runs and programs the CNC
machining center after I design parts and he's working lots of overtime
at his job and I keep getting waylaid on other projects. Working on the
reverser input drop box right now, keep changing the design and started
over with different gears and offsets so I now don't need to run a
driveshaft with high dollar/ high speed u-joints (which I already have
here). My motor sits low and tranny sits high and stuff lines right up
now. Diesel motors just don't line up with the cub rearend. Have a
homemade billet flywheel with clutch partially built into it. I took
the drive train to a fair this year and it seemed to draw a lot of
attention but some of this stuff I have a ton of 3D design hours and
machining programming and don't just want everybody's eyes on it
uncovered yet. We'll see.

--- In nwohiogardentractorpulling@yahoogroups.com, "ed"
<tractorjack66@...> wrote:
>
> Hey Bigkrank you going to have your deisel at Columbus ?? It would
be
> cool to see even if you don,t have her going yet..
>