Steve,

If you add the "front lines and back lines as a continuous loop" idea
(from Flysurfer Psycho or RECON - I don't know who copy who) to your
design then it may work.

As a continuous loop, the back lines will keep the front lines where
it supposed to be and when you make the back line slack (sheet out)
the front lines will move gradually forward until it completely
depower the kite 100%.

This idea should work in principle but it may not work for current
sled LEI as the center of lift and the connections points may be in
the wrong places for its purposes.

Hung.

--- In kitesurf@yahoogroups.com, CC - Steve <kite_head@n...> wrote:
> What I did to Seasmikize my Wipi 8.5 Classic was to sew some attach
points near center of leading edge, then run lines from standard front
attach points to these new attach points with a slider on them. When I
> sheeted in kite flew normal. when I sheeted out liders would start
to move toward new attach points. The problems I had were 1. Even at
full sheet in the sliders had a tendency to be a bit forward of where I
> wanted them. 2. When sheeted out sliders did not go all the way to
where I wanted them, so I got more than stock sheet out but not as
much as I wanted.
>
> It was at this point that I abandoned my experiments.
>
> I posted some of this to the group back then.
>
> Steve.
> Carson City, Nevada, USA
>
>
> 9/17/2003 6:32:32 AM, "hungvuatnetcomdotca" <hungvu2000@r...> wrote:
>
> >--- In kitesurf@yahoogroups.com, georgeiw@a... wrote:
> >> The way the middle line goes from being a brake line to the B/A line
> >> regulator is similar to the way the lines work in the Cabrinha recon
> >system where the
> >> front and rear lines are a continuos loop with stoppers to lock it
> >into the
> >> powered position.
> >
> >I am not sure who comes up with the "back line/front line as a
> >continous loop" idea, Flysurfer or Cabrinha (in their RECON system),
> >but I can see that this idea can be used for a 100% fully sheet out
> >sled LEI kite (which of course eliminates the safety leash and
> >automatically flip the kite over on its back ready for relaunch)
> >
> >P.S., I do hope that the "back line/front line as a continous loop"
> >idea is not patented (I don't think it is as you need some very
> >specific application for patenting); otherwise, only one company can
> >built 100% fully sheet out sled LEI kite.
> >
> >Hung.
> >
> >
> >This group is sponsored by KiteHIGH.com Kitesurfing
> >
> >http://www.KiteHIGH.com
> >ph: 1 866 646 7835 Toll Free USA or
> >ph: 1 808 637 KITE (5483)
> >Em: support@k...
> >
> >Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
> >
> >
> >
> >