HI Joe here is a link for the 5th line set up from kitesnowboard.com http://www.kitesnowboard.com/Content/MediaRoom/Fifthlinesetup.html you will get some info...
Richard is right; Pete Wallenda is currently working on the new 6 and 12m kites. But the 9m are ready. W.M. International is currently importing (USA) the new...
Happy New Year to one and all.... I feel very lucky to have spent 2 days getting to know a 9.5m (?) Frenzy at Newborough beach on Anglessey - on New Years Eve...
could they have been snowmoblie tracks? ... From: Alger, David To: 'kitesnowboarding@yahoogroups.com' Sent: Monday, December 30, 2002 10:56 AM Subject:...
Thanks for the info Dan, I looked at the kite, and once I stripped off all the bridle lines, and rolled up the ends (for 4 line flying) I notice two bridle...
thats the ones Joe use those points they will reverse it good luck Dan Sheridan http://www.kitesnowboarding.net http://www.kitesurfingcanada.com Serving Canada...
6 new kiteskiing/snowboarding wallpaper images added to Doomwheels: http://www.doomwheels.com Navigate to the "Desktop" section. Next update: Articles and...
I'm looking for more USA Team Riders for our new line of Wallend-Air Kites (www.wallendair.co.za). If your really good on snow and motivated, drop me a line: ...
HI Guys my prototype kitesnowboards arrived today so i sent one with Mika out on the lake he says they ride kick ass smooth and sweet maybe if Mika reads this...
HI Dave no not yet on the straps that is my next conquest i have the parts for the straps bindings i just need the time to wip em together and see if they work...
Todd, Mike, Ian, Jim... It was great to meet/be in touch with you guys while I was home over the holidays. Thanx for inviting me out and all that... Cheers... ...
No Problem Nadina, It's too bad that we didn't have favorable winds when you were here. We did however have a fairly decent (but WET) afternoon the day after ...
hi Nadia It s Too Bad we didnt have wind for kiting on Sat. We went to another lake to try on Sunday because chestermere was all water. The lake we went to was...
I bought 2 Frenzy Ozone for my husband and me. We are very pleased with them. However, adjusting the depower line while riding is quite difficult because the...
Hi Maria, Where are you based?? I'm in BC at the moment (on holiday from England) and have a 9.5m Frenzy here with me... the only problem is THERE'S NO WIND!!!...
Hi all, I hope these questions aren't too stupid....... 1. What are leashes used for in regards to snowboard bindings? 2. What's with the "stomp pad" on...
leash: used to keep your board attached to your boot, if board should fall off. Not all that usefull, but required by some ski resorts. Stomp pad: Used when...
Hi All, Some of us kiters here in Alberta, hit the mountains this past Sunday and had an Excellent day. Due to our lack of snow, we headed out to a Mountain...
Thanks Troy, my eyes are now open a little wider! :-) Brock ... From: Troy Bezanson To: kitesnowboarding@yahoogroups.com Sent: Monday, January 13, 2003 11:23...
Hi Dee, Sorry, I am pretty far from your place. Here in Montreal, we have plenty of wind and finally some good powder snow on the lakes, though not enough in...
I've been skating (on skates) down to the kite to prep it prior to launch on ice. With a snowboard, do you walk down, or do you have to have an assistant?...
If you're using a foil, then 2 coke bottles in a bag would keep them from rolling away. I've used windshield washer containers and found that they work pretty...
Hi All, If it's a foil? The only way to go is to get an ice screw and anchor your brake lines to it. We've being launching and landing unassisted this way for...
Yea, Mike... The ice screw is the only way to go.. a short one (8 cm?) will fit in your jacket pocket just fine, and is plenty strong enough on any ice good...
Thanks, Troy and Mike. Very helpful. Its a 4 M foil, so it will be launching downwind for a pop. Currently all we have is ice so I will be on skates or...