Well i myself just started late last year and ran at a couple places to test im looking for a group to go with this year as long as my mowing business doesnt...
I use a linkage set up on my pulling tractors. It'll last the life of the tractors. Cables bind & have been known to break after a while. In a message dated...
I have a Full KT17 that was running before it was pulled out of tractor its a vertical shaft and looks like its in good condition will part out if anyone needs...
Dear Member I just wanted to say a quick hello to the group as I am a newbie! I am off for a long weekend break, but I hope that I can be an asset and...
Im looking for some pictures of your guy's drivetrain setups on your motorcycle powered pullers. Im going to be running a late model Kawasaki, but I have no...
http://www.skhr.net/bfapullers.com/frame.htm keep it simple and run the chain drive setup, these guys can help with sprocket selection and jackshaft/axles,...
I found the bfapuller site doin some searching on google. I like their design. Only two things I can't tell by their pic's are what they use for a brake setup,...
Okay im building another k301....i know the STD bore is supposed to be 3.375...... and for some reason when measured with tape measure it reads 3 1/4" which so...
What you have is a thick-cylinder wall 10hp block. I think they were supposed to be a 12hp block, but the factory must've ran out of ordinary 10hp blocks & ...
They used K301 blocks to make some of the K241s. They only bored them to the 10hp size. I would say you have a 10hp in a 12hp block. Bud in PA ... [Non-text...
Okay yes i just read the part on brians website about the k301 with the 10hp bore thanks for all the help. Damon. pullingtractor@... wrote: What you have...
My part Number is 808278. Which is the old style 2 barrel for the 20hp. I believe a 808626 will also work. I am not sure if the new style 2-barrel carb with...
Yes thats for the regular k301 i have a 10hp k301 stamped block that has a std bore of 3.250" what would the max be for it if anyone knows. Damon Bud...
Okay so basically it will still bore out to 3.405" at .155 over? Or am if off somewhere? Damon. Bud <rodeo3@...> wrote: You have a regular K301 block....
.155" is only .030'" over 1/8". This is only .015" over 1/16" on each side. Flip the block over and look how thick the cylinder wall is. It will easally take...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
