Okay so that would rule out the steel 18hp cam but i have another question when it says no core on a cam what exactly does that mean. Damon ... Want to start...
Who can you get to regrind a cam for my K-181.. And since the base circle would be smaller.. do I use longer valves or add adjustable lifters to make up the...
you dont get any extra lift from a reground cam.. all you get is longer duration. the valve stays open longer. Madsons service can grind it for you. ...
No core means they don't require a trade in. They sell it outright. In a message dated 2/1/2007 7:15:19 AM Central Standard Time, metakiller2000@......
Guys, If you regrind the stock cam using a different profile lobe master, it will remove material material off the base circle (back of the lobe). You continue...
So there has to be a lobe master to use first?... Who do you have weld up the lobe for extra lift... and what would be a maximum lift for this little engine?...
Sure you can, and I didn't mean to discredit that point. I just don't think he's gon'na have the room on that 181 to put tooo much "Lump" on it!!! Randy...
I can machine you a head either by you sending your engine or if you have a way to measure the dimensions I need, you can send me a set of specs. I sent you an...
Custom billet cylinder head, to specifications for your engine, is $175. I can send you a worksheet with fill-in-the-blanks for the dimensions needed to make...
Just curious, is the $175 for labor to machine the combustion chamber, or is it with the head, too? In a message dated 2/2/2007 12:17:21 AM Central Standard...
Okay ill see what i can do here in the next week or two. Damon ... Need a quick answer? Get one in minutes from people who know. Ask your question on Yahoo!...
Typically, overdrive gears are not based on cost, or even a rule of thumb. Mostly, they are used to offset a set of gears that are not tall enough to do the...
Go here: http://members.aol.com/pullingtractor/intro.htm . In a message dated 2/2/2007 11:29:05 AM Central Standard Time, dpwynkoop@... writes: > I'd...
A stock class is a good way to "get the feel" for pulling. In a message dated 2/2/2007 1:04:34 PM Central Standard Time, gunrunr298@... writes: > like i...
1. How many CFM do a STOCK #26 carb flow 2. Can moving the spark plug location on my K181 help make more power.. I was thinking maybe locating it above the...
So you cant run in stock altered if you have a cast iron flywheel? To me that doesnt make sense beccause i run that many rpm on a stock tractor and it doesnt...
A stock #26 Carter or Kohler carburetor with the venturi intact flows 74 CFM. And position the spark over the exhaust valve for more power. The more heat the...
This is just a curiosity set of questions I thought of after reading these posts. What does a stock #30 carb flow for CFM's? What does a bored out #26 flow for...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
