Some of the messages that I have recieved are comming thru in html code. It has been affecting how the E-Mail displays when I open them,I have seen the problem...
In a message dated 7/1/04 1:22:54 PM Central Daylight Time, dspiresjr@... writes: > Some of the messages that I have recieved are comming thru in ... All...
Can some one shed some light on the tire hardening process? I have heard that you can heat the tires in an oven for a few minutes then let them cool down and...
I heard it is a chemical process to remove the oils that keeps the rubber soft??? I'm not sure either. Dale ... Can some one shed some light on the tire...
Weigh in is @ 4 p.m. and pull @ 5 p.m. Will pull open class first and lightest class last! Call Jeff @ 1-859-299-9064 or Robert @ 1-502-227- 7406 Information...
Where in Oquawka ? I live near there and would love to check it out as I'm interested in getting into pulling with my old Wheel Horse. ... this ... 1160...
I have a ch25 carb also have some starters . have several kolher twins that i am parting out if i can be of any help e mail me at abswartz@... ... From:...
Thanks, sounds like it might be a little wet but at least it won't be muddy. ;o) For those not familiar with Oquawka it's on the banks of the Mississippi...
The e-mail problem lies in the code "Yahoo Groups" uses. On there trouble shooting web page, it says they have been fixing things affected by an internal...
Cheney, Ks July 10 2004 Register at 9:00A.M. Pull starts at 10:00A.M. This is a Kansas Heartland Club Pull...All are welcome...See their web page at...
Cheney, Ks July 10 2004 Register at 9:00A.M. Pull starts at 10:00A.M. This is a Kansas Heartland Club Pull...All are welcome...See their web page at...
The pull scheduled for Saturday at Wellman, Iowa was rescheduled for July 5th at 2pm. Stock 10hp 1000lb, stock single cyl, stock 20hp & under twins, stock...
Just acquired a Roper 20T tractor made for sears by roper. Was wandering if this tractor has the proper rear end and trans to make a pulling tractor. Any info...
if it has the 3 speed with high low range then yes it would be good for pulling . but i wouldnt try to make it into anything more then a altered stock. some of...
what is the best carb to run on a stock K 301? ... Do you Yahoo!? Yahoo! Mail - 50x more storage than other providers! [Non-text portions of this message have...
Redneck Logic These two backwoods rednecks, Bubba and Billy Bob, decided they should go to college so they could get ahead in life. Bubba went in first, and...
Fair pull scheduled for Tuesday, July 20, 2004. For more information http://commonwealthpullers.com/ or call: "CGTPA, Inc." Contacts: Robert Darnell...
I was reading the list of events at the Washington Countie fair in Washington Iowa and I seen that they have an adult petal pull....what is this???? and it...
"Mr.Smoothe #86" <racin_idiot_74@...> wrote:I was reading the list of events at the Washington Countie fair in Washington Iowa and I seen that they have...
The CGTPA will be having a garden tractor pull at the Spencer County Fair, in Taylorsville, KY on Tuesday, July 20th. Weigh in will be at 6:00p.m. and the pull...
Ok first a little about what i have I have a wheel horse, high and low range with a little 8 hp techumsea engine on it till i get my bigger techumsea fixed,...
Ok first a little about what i have I have a wheel horse, high and low range with a little 8 hp techumsea engine on it till i get my bigger techumsea fixed,...
when is the pull and where is mont, in pa , what class are you having thanks massy pulling team [Non-text portions of this message have been removed]...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
