---What would you think of tig welding a cam with A-2 rod?
Thanks,
Grumpy


In gardentractorpulling@yahoogroups.com, "leonard parks"
<ljackparks@h...> wrote:
> don't mean to but in , but you really have to understand the
properties of
> metal to know why
> if the cams are done in an eviroment where unwanted wind
occurs ,this will
> change will change
> the weld at any point to harder or softer, especially if a wire
welder is
> used,the transfer of gas may have been interupted, causing the one
lobe to
> be softer!
>
> >From: bambam1300 <no_reply@yahoogroups.com>
> >Reply-To: gardentractorpulling@yahoogroups.com
> >To: gardentractorpulling@yahoogroups.com
> >Subject: [Garden Tractor Pulling] cam standing
> >Date: Fri, 04 Mar 2005 05:01:02 -0000
> >
> >
> >i would like too know more my cam went down the same way i was told
> >im yousing the wrong oil funny only 1 lobe rounded nothing else was
> >damaged and i have all the equipment for checking spring rate coil
> >bind and install hight butt most cam peaple have springs too match
> >there cam they offerd no springs too match there grind and no open
> >and close guide lines maybe my fault butt all springs were checked
> >and only 1 lobe failed BAMBAM
> >
> >
> >
>
> _________________________________________________________________
> Express yourself instantly with MSN Messenger! Download today -
it's FREE!
> http://messenger.msn.click-url.com/go/onm00200471ave/direct/01/