I have a 1977 Pursang 370 M193 and have a 36mm mikuni on it. It will start but not rev. I have a 35 pilot, 280 main, Q-8 needle jet, 2.0 slide and a 6DP1...
Tim, I don't have Bultaco 36mm Mikuni jetting specs, but I did look at my 380 CZ 36mm Mikuni jetting specs, and except for the CZ using a Q-5 needle jet, and...
Rick: Yes I looked at the float levels, on my new 36 and old 36 and a old 38 carbs still the same result. I have adjusted the timing, only thing I havent done...
I wonder if the guy in the coverall's is one of the Rickman brothers? The guy leaning on the aluminum fender better be careful he doesn't bend it. Rick...
Happy Father's Day to all. whom ever the gentleman in the overalls is, doesn't really matter... he just looks really bitchin'. also the other gentleman isn't...
... Thanks very much. I recently bought a 77 Pursang 250, from the owner of North 40 MX in Sherman. Have put one moto on it. Hmmm... many many neutrals in the...
So went to wore on my "new" Bul, I mean one has to know what they have in there after all...it was a mostly restoredm, running bike. but uh, hmmm.......
I've never replaced a liner before, (never needed to), but a couple of my CZ friends that restore bikes for a living say it's not too bad once you get the hang...
Yes, Will send it out, spoke with Gerald Jessup today about it. And sent a l o n g list of parts wanted to Hugh's... I wonder how the pricing difference is...
So, in my phone travels today, I could buy a ready to go 167 cylinder, with a 192 liner in it. Would my 192 Head work? are there any performance issues ?...
I am vairly new here so please bear with me. I was just curious if anyone deals with Hogan's in Mass. I have and always had a pleasant experience. een awhile...
I got an Email from Hogan yesterday. Still no brakes for my other brand trials bike. Any one out there know where I can get Ossa brakes? Uncle Bill In a...
Hey, take it to a OSSA mailing list! Just kidding. http://www.vintagedirtbike.com/ They even have an online parts book for many Ossas. Check that out! The...
Replacing the liner is not too hard. Just heat the whole thing in the oven upside down at 250 degrees and it should just fall out. The new liner from the...
Some Ossa brake pads in this Spanish site:
http://mototema.com/tienda/index.php?cPath=46&sort=2a&page=2&osCsid=748a2a6bafa1e81364176345390b8e60
If it's just...
Hey Rick, He's picking on me!!!! Nope been to all those places, NOBODY has any. can'tstopbill In a message dated 6/21/2007 3:01:47 P.M. US Mountain Standard...
I was considering doing that part of it. Would save me $100 :) The rest of the motor seems tight. Hard to tell when a new rod bearing is needed. A knocking...
Thats what my friend Lee Holth, who's a CZ master, says, but he's the kinda guy (CZ Guy) that makes things like that look easy. Rick Ana & Craig Parkinson...
Good day all. a few finer details of cylinder liner replacement may be in order here. you will need to completely clean the cylinder first. no gasket...
Much fun :) Actually I have decided to send it off...when you have one of the best Bultaco guys to work on it, you get a lot of experince. it's going there for...
