item # 300125280108 60cm ... Nice pictures, too - you'll really enjoy looking at this one. No relation to seller, etc. - just saw this while browsing and...
its a looker, but im just not seeing a $1200 bike here... someones sunk a lot of money into this one, yes, but the value of a bicycle isnt necessarily equal to...
... Yep, I agree. And I'd bet dollars-to-doughnuts that that's not a low-trail fork, either. It just doesn't look like it's got a lot of offset to me......
FYI, this bike showed up (minus the porteur rack) on the Velo Orange blog some months back, where it was referred to as a "low end gas-pipe Peugeot" that had...
Were addition forks shipped with shipment containing the G2 P/R? I recall seeing mention of them but can't locate the thread. What combinations of, brakes...
... I'm going to ask a much more specific but related question because those seem to work better. Did any forks come with this shipment that have a 30mm trail...
Neat build, for sure. Looking at the lugs, I am pretty sure this is a gaspipe frame though, and none of the pictures really give a clear shot of the dropouts...
... Here are the forks that are coming: 9/8" dia, 400mm long, threadless steerer, 1.3mm walls (not threadable) A: offset: 58mm, brake->axle 366mm, pivot 268mm...
... No fenders on the 700C model, though, right? Is this [http://kogswell.com/images/SR.gif] the final geometry spec? Finally, is a seat-tube collar...
... I use a hacksaw. I have an old and damaged stem that makes a good cutting guide to get a good cut. You can also draw a line around or just use a pipe...
OK, I ahve heard this advice before, but it isn't apparent to me how one uses a stem to guide the saw... Do you clamp them on top of one another? I am sure...
I use a hacksaw. When I'm cutting 1-inch threaded steerer tubes, I dig up a set of old steel adjustable headset cups -- preferably the kind that come on ...
... I've had good luck using a cheap (under $10) pipe cutter. It does, as Alex says, deform the metal, raising a little lip, but this is easily filed off. If...
... I also use a hacksaw, preferably with a sharp blade. I use a headset cup as a cutting guide, putting the wrench flats of the cup in a vise and cutting...
If you have one (or better, two) threadless stems that you can scratch up, you can position them on the stem to provide cutting guidance (the saw goes against...
... If you read between the lines of what Neal is saying, you'll see that it makes sense to hang on to 1" steel threaded headset cups as they come your way. ...
I've been playing with these hubs for a week now and I am completely enamored of them. But I felt dumb talking about them more than I already had. So I just...
KOGs, ... I'm very interested in reducing the trail on my P62, especially since I've started to use a handlebar bag. I'm wondering how the Konversion Fork...
I have never cut a steering tube. But if I ever do. I will go to my neighborhood metal supply house at quiting time with a 6pack of beer and chips. Have them...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
