On Thu, Sep 24, 2009 at 1:28 PM, Dominic <dmorellonh@...> wrote:
>
>
>
> Bruno I checked this morning and there are no screws on the bottom of the
boom.

Bottom of the frame where the boom meets it? There should be a cut in
the frame below and 2 screws, or at least the mounts for them, can you
take a picture of it? Loosing those 2 screws would be a mistake, since
the 2 bolts on top aren't enough to hold the boom in place when riding
harder.

> Must be a change in the model. I think I will focus more on the chain the two
bolts on top. I am tinking of putting some lock tite on the bolts so they don't
get loose from all the shake, rattle and roll that goes on during the ride.
David also recommend that in time the slipping of the boom will stop the bolts
set in.

I've seen booms that are cut in the top left corner because the 2
bolts weren't enough to hold it and since the aluminium is softer than
steel.

I'll check your photos on the yahoo groups page and take some of the
frame near the end where the booms meets it.

Cheers