The only item I can't seem to locate is a tank badge. This is not really a decal. Instead it's a laminated Husqvarna logo that's not as wide as today's logo....
Are you looking for the plastic badge they started using in 1984 on the plastic tank? Try European Dirt in Silt Colorado they might have one. Brad arnec2002...
For everyone looking for a hard to find part or a project bike. I just visited a shop in Jeannette PA that has a bunch(200-400) of old bikes inside and out. ...
Sorry for the spam but have to part with my 75 Husky 360CR. Want $800 for it. Just changed points and plug, cleaned the carb. Comes with these extras decent 2 ...
I'm looking for a chain tensioner for an ML frame if anyone has one. If not maybe a couple of close up photos of their's via email so i can make one. My 76 cr...
I'm looking for a chain tensioner for an ML frame if anyone has one. If not maybe a couple of close up photos of their's via email so i can make one. My 76 cr...
Hi All, I'm looking for a Husky 175 top end for '73-'74 Husky....Goes on a 125 bottom end...Just need cylinder and head... Anyone have one to part with ? Email...
Hey Guys, I need some help..I haven't ridden my '82 250CR in about 3 months..so today I pulled the carb & cleaned it, cleaned the air filter, changed the...
Has anyone else had a problem installing John's grey leg fork seals? They seem slightly too wide and I just make matters worse trying to force 'em in. Any...
Sounds like the wrong seal to me, but I could be wrong. I buy my seals at a place here in Denver, Co called Rocket Seals. They were a perfect fit and have not...
Buddy, After checking that everything's grounded well, especially the coil, and if you can find a good coil to swap out, and that the plug cap is good, etc.,...
John, I think I can help you out, but I will have to dig out some boxes from the storage garage. Maybe by this weekend I will have some pic's for you. Tom...
Hi Guys, I need an NOS or Good Used Clutch Pressure Plate..I looked in my parts books and it looks like there the same from 1975 thru 1982 250/360/390/430..let...
Check with Andy Hardin, pvpcycles.com, 1-888-634-4949. Andy is a long time Husky dealer in Louisville, KY. He has an excellent selection of vintage and post...
My brother has a shop in Maryland, he might have one or could get one for you. www.mcofmd.com 301-293-1720 ask for Chuck and tell him Brad sent you his way. ...
Guys, I need some help from some Husky guru's..I took the clutch cover off of my '82 430CR to replace the clutch plates(& pressure plate) when I put it back on...
One of our members (who shall remain anonymous for the moment) sent in the cool pic on the opening page. Trivia question Who is it? Where was it taken? and ...
Looks alot like that clip from On Any Sunday where Bruce Brown tells how Bengt Aberg (sp?) uses throttle to straighten himself out. No idea where though....
first the $1000 elsinore tank on ebay - now this http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll? ViewItem&category=35618&item=4542676735&rd=1 item 4542676735 ...
"...Swede Bengt Aberg... here using power to straighten himself out. Scientific test have been made and motocross was found to be the second most physically...
HAMMER & TONGS May 29 July 24 August 28 ... VDR Season starts at Ward Creek Sept 11 Ward Creek then to WOODLAND Oct 22 Nov 5th Dec 3rd Jan 7th Feb 4th Mar 4th ...
