Post a picture. From: "Sonny Solomon" <sonnysolomon@...> Reply-To: HuskyOwners@yahoogroups.com To: <huskyowners@yahoogroups.com> Subject: [HuskyOwners]...
Best way to tell is probably by getting a parts manual or cd, usually available on ebay for an inexpensive price, then check the differences in part numbers....
need to remove kick start arm to replace clutch cover gasket removed circlip but kicker will move side to side but will not slide off shaft looks like it...
Check out this link. This is where I ordered my from for my 84 WR 400. Took about 2 weeks to arrive. http://www.mxm.co.uk/motocross_makes/husqvarna.html John...
Try Barry Pate ppate10416@... Tell him Rusty sent you. ... From: mike To: HuskyOwners@yahoogroups.com Sent: Saturday, September 02, 2006 1:38 AM Subject:...
hey Everyone a quiet Sunday Morning. I'm just now finishing the Gallery/points/etc for H&T 2006 I'd like to thank everyone who contested Hammer & Tongs this...
i first posted this as a carb problem because when i would apply pressure to slide with my finger the revs would drop installed slide from my 430 that looked...
i first posted this as a carb problem because when i would apply pressure to slide with my finger the revs would drop installed slide from my 430 that looked...
Did the problem start soon after making any other changes or modifications? Is it a Mikuni carb. If it's a mikuni do you have a proper slide in it. Mikuni's...
Hi Joe, Is the rubber gasket inside the carb cap there and in good shape ? Was cap on straight ? All can cause air leak...May be mag side crank seal....Behind...
WHERE O WHERE, Gentlemen, can I get fiche for my YZs? also my CZ400- was there such a thing? and the Husky 360.... I don't want to look online, I want the...
With all the expertese and experence with this group, does anyone have any infor for carb size and getting to work on a 1972-74 Husky 125 CR/WR/SC models for...
Now that was a pleasure to read. Thanks for sending that out to all of us. I only hope that no one out there ever feels bad about paying tribute to the ...
anyone out there have a diagram for a 1982 husqvarna xc 250 also what oil should i use in the clutch i was told 10w30 but i want to make sure as i only have...
I was wondering if someone might be able to shed some light on a problem with my Mag 250. It has a freshly rebuilt motor, it has spark, and the carb, including...
Stan, Good idea, but whenever I use silcone near oil, it softens or melts and comes off. What type do you use? Thanks, Robert Hank Beni <nats3478@...>...
Hey Brian, How you doing? Is the pilot jet the right size (big enough)? The Motoplat is the usual culprit for hard starting. Do you know about getting them...
Sounds like the same problem I'm havin' with my '76 360. This thing has 11.5 compression ratio and when it kicks back, it hurts. I've tried push starting in...
Hi Chuck, Is the 360 a CR or WR ? In any case, they all had a rep for being hard to start....A number of things will really help...Get a kicker off of a '79...
