I use hydraulic oil 25W or ATF, ATF is preferred if you have no leaks. If you use Hydraulic oil change it often. My Internet service has been off for a couple...
It would be nice to see a good group up there! I'm trying to go through my 360 auto and get it ready. I rode Zink earlier this year and it was typical - wet,...
... No, it's in OKLA., just west of Tulsa. They ran the '94 ISDE there. Mr. Zink is famous in motorsports dating back to the 50's when he entered a car in the...
Steve, when I had my Husky I would take the seals down to a seal and bearing house and get them there. Look on the inside of the seal, it should have the 3...
Steve I'll be going on Sunday only, but as a spectator. My '98 TE410 is too modern to ride and I don't have a vintage husky yet. Does anyone know of any good...
Hi Steve, The shift shaft seal on the left side is 17 28 7 there is another seal on the right side behind the counter-shaft sprocket cover it is 15 26 7. NOTE:...
Hi all, another new guy to the group, the name's Mudslinger. I don't own a Husky yet, I'm in the process of talking my Ol' Man into selling me one of his 450...
Hi all, I'm looking for either a 400cr, 450cr, 400wr, or a 450wr (I'll also consider an oval case 360 or 400 Cross the right hand shift would be wierd to get...
themudslinger77, I have a 1972 450 wr that is alomost re-stored and a complete 1973 250 wr (not running) that will come with just for some extra parts. I'm in...
Hello Group: I am looking for a ProFab pipe like the one on Bill's bike. I have a '73 CR400 with the biggest freakin pipe you've ever seen. If you know who to...
i have a restored 73 400 cr that i would be willing to sell. i need $2,800.00 for it the way it sits now. if i remove the rear ohlins, and put on some...
Hi all, here's a new Husky site to check out: www.geocities.com/husky_net I'll be updating the site frequently as projects progress, and as new projects...
Ray; you can buy a circle F for about 170.00 from vintagedirtbike.com.....or for 325.00 you can get a pipe from hrhusky.com for good info about pipes and...
I just learned that Ray has passed away after a short battle with cancer. Open up any of your VMX Magazines, and in the Old Gringo page, right up front, you'll...
I'm putting my 1973 Husky 125 back together and can't locate the spec sheet that came with the PVL ignition. Anyone know the tightening torque spec for the PVL...
Looks like 40 ft.lbs or mfg spec - whichever is lower. Can anyone help with the mfg spec for torquing the rotor nut? Here are links to pages 1 and 2 of the...
raced mine for the first time last weekend - forks sack between and inch and a half and two inches without me on it. Forks are the double ribbed Any...
Progressive sells fork springs. The ones for 35mm forks are #11-1135 Go on their site at http://www.progressivesuspension.com and go to springs then to...
