you can take the seal to any bearing shop most of them also sell seals to. I get my at tri state bearing in Evansville,In there phone number is 812-425-1336...
Nothing obvious because on later dates it ran fine. After the race, I changed the oil and checked the compression. I figured it had simply overheated....
Hi Beth, What happened to the bike which made it lose power? You said that it "recovered," but obviously it needed to be repaired. Thanks for the reply, Doug...
I have a set of 1mm over size Hap Jones pistons in my race bike. We have the head off for some valve work. I am trying to locate a set of stock Honda 1mm over...
Doug; I'm sure others will have some good tech advice for making your 175 12 hr endurance race ready. It will need some motor/head work I'm sure. Last summer...
Hi Everyone, My name is Doug Walker. I have been around motorcycles for the last 40 or so years in various capacities. I grew up by Lake Erie, but have lived...
Was trying to avoid answering this. I am a lil anal. I might reach out through DMV for a title search of PO's, and write each, asking. If they know the shop,...
Bill; your 175 and mine are good examples of what can happen when upgrades/mods are not done carefully and knowlegeably. I'm going back to a stock cam and...
My bike had them and a Megacycle cam prior to this current build. The bike had too many mismatched speed parts from previous owners so in an effort start fresh...
My CB175/200 race bike, which is still a project, came with cam roller bearings installed. The prev owner wasn't sure about the details as many people here in...
I know Megacycle does roller bearing conversions for other Honda engines. I head them done to my CB350 race engines before. Might try asking them if they have...
This is a topic of interest w me but no time yet to look. Tried google Advanced. (Use it a lot.) Maybe one of these will trigger a memory??? I wonder about...
Steve, Guys have been running needle bearings for the cams for years. There is a kit out there to make it happen. Some one will chime in with the info I am...
Robin, Hmmm those are nice setups.... I should never have reground them stock valves! :/  Oh well, I will get those on the next go round! Thanks, ...
I am going through the Honda 175 motor this month. The plan is to rework the head and get everything fresh for next spring. One weak point we found is the cam...
Robin, Will do, it will be a little while still before I run em, but I will let you know. I don't expect them to last a very long time, but I will see. The...
Heathen Please let me know how the re-ground followers work for you. I have 100 or so that I would like to get done. I have destroyed 10 sets. Radical cams...
All, Have any of you tried the Delta Cams 'HP160 road racing' cam profile?  It's a 147 degree / 0.154 lift / stock LCA (all measured on the cam itself, not...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
